HomeButtonProductsButtonFAQ ButtonVideoDemoButtonCommercialsButtonStoryButtonOrder NowTestimonialsSupportButton
User Guide

Using iLoad with your iPod for the first time

Before using your iLoad with any iPod for the first time, you'll need to "introduce" them to each other using the iLoad Setup CD. Skip this step if you are using an iPod Shuffle. This procedure enables your iLoad to identify the music information from CDs that you will load onto your iPod and it will not damage your existing iPod music library.

You will need the following items:
• iLoad Setup CD
• iPod
• USB connector cable that came along with your iPod
• iLoad device
• iLoad power supply and in-wall power cord
• Access to a 110V or 220/240V AC power source (use an adaptor if you are not in the USA)

Here are the easy steps:

(1) Plug the small round end of the AC power supply into the corresponding receptacle on the rear of the iLoad unit. The correct receptacle is correspondingly round and has a green ring around it and it’s marked “Power”. Then connect the wall plug on the opposite side of the power supply to your AC power outlet. Using the USB connector cable, plug the thin wide end into the base of your iPod, and the other end into either of the two USB connectors on the rear of your iLoad.

Be gentle and never force a connection. If you have difficulty, you may have the connector upside down.

(2) Press the power button on your iLoad Control Panel. The iLoad system processes are starting.

In less than 30 seconds, your iLoad LCD screen will read:

Welcome to
iLoad™
Version 1.23
version number will vary with your unit

When iLoad is ready for use the LCD screen will read:

Press GO to Read CD

(3) Insert your iLoad Setup CD into the slot on the front of the iLoad (It's best to hold CDs by their edges so you don't get fingerprints on the CD). As you insert the CD, insertion will be completed by the iLoad. Wait a few seconds for the CD to seat.

(4) Press GO button on the iLoad control panel. Your iPod display screen will now read "Do Not Disconnect". That's good advice!

(5) After a few seconds, the screen will display:

Press GO to
Install setup CD

Progress to completion will be displayed in percent complete. This procedure will take just under six minutes. When the process is complete, iLoad will eject your Setup CD (keep it in a safe place. You'll need it any time you first "introduce" a new iPod to your iLoad). You are now ready to copy your CDs to an iPod.

Previous Page Previous Page                                                                                                                        Next Page Next Page

Page 1: Version 1.02 User Guide

Page 2: Your iLoad

Page 3: Warning Before you Connect Your iPod to iTunes

Page 4: Using iLoad with your iPod for the first time

Page 5: Easy Steps to iLoad

Page 6: Advanced Options

Page 7: Updating Missing Song Information Without an Internet Connection

Page 8: iLoad Backup Service

Page 9: iLoad 90 Day Limited Warranty Terms

To receive information and offers about iLoad products, please enter your email address